5 network, 1 dhcp:xx / bootp:xx, 2 ip address – Konica Minolta Magicolor 5440 DL User Manual

Page 120: 3 subnet mask, Network -17, Dhcp:xx / bootp:xx -17, Ip address -17, Subnet mask -17

Advertising
background image

Main Unit Field Service

Menu (magicolor 5430 DL /5440 DL)

3-17

III

Ad

just

men

t/Set

ting

M. TRANSFER VOLTAGE

4.5

NETWORK

4.5.1

DHCP:XX / BOOTP:XX

4.5.2

IP ADDRESS

4.5.3

SUBNET MASK

Function

• Adjusts the Printer if there is an image problem such as void areas or white spots.

Use

• To adjust the printer when void areas or white spots occur due to the characteristics

of the media being used.

Setting
/procedure

• The default setting is “0.”

1. With RESTORE USER DEFAULT selected, hold down

T

key for 2 seconds.

2. With TRANSFER VOLTAGE selected, press the

W

key /

X

key as necessary to

select the appropriate adjustment level value.

: If void areas occur, adjust within the plus levels.
: If white spots occur, adjust within the minus levels.

Adjustment range: -8 to +7 (16 steps)

3. Press the MENU/SELECT key to validate the new adjustment level setting.

Function

• DHCP

: Automatically acquires an IP address from the DHCP server, if there is one

in the network, and specifies whether to load other network information.

• BOOTP : Automatically acquires an IP address from BOOTP and specifies whether

to load other network information.

Use

• To automatically acquire an IP address and load other network information.

Setting
/procedure

• Turn “ON” either DHCP or BOOTP or “OFF” both.
• The default settings are “DHCP: ON / BOOTP: OFF.”

DHCP:ON / BOOTP:OFF DHCP:OFF / BOOTP:ON

DHCP:OFF / BOOTP:OFF

Function

• Sets the IP address of the printer on the network.

Use

• To enter the printer’s IP address.

Setting
/procedure

• Enter the IP address using the up, down, right, and left arrow keys.
• The default setting is “192.168.1.2.”

NOTE
• Before manually setting the IP address, turn OFF DHCP and BOOTP.

Function

• Sets the subnet mask of the printer on the network.

Use

• To enter the printer’s subnet mask.

Setting
/procedure

• Enter the subnet mask using the up, down, right, and left arrow keys.
• The default setting is “255.255.255.0.”

NOTE
• Before manually setting the subnet mask, turn OFF DHCP and BOOTP.

5450_E.book_PDF.book 17 ページ 2005年4月12日 火曜日 午後12時54分

Advertising