Konica Minolta PageScope - Manual (Page 16)

3 Browsing Network Devices
11
3.5 Configuring a Device with PageScope
Network Setup
This section describes the procedure for network printer setup with
PageScope Network Setup.
First check the following points relating to your network environment.
Check with your network administrator for details about the network
environment.
• The protocol used on the network (TCP/IP or IPX)
• Connection format of the device (peer-to-peer or via server)
Use one of the following procedures to configure the device. The
procedure you should use depends on the network connection.
For peer-to-peer printing with TCP/IP connection:
1.
Verify the device setup status. See 3.2 Verifying Device Setup
Status.
2. Setup the device TCP/IP connection. See 4.2 Configuring TCP/
IP.
3. Setup peer-to-peer printing. See 5.1 TCP/IP Peer-to-peer
Printing.
For peer-to-peer printing with IPX connection:
1.
Verify the device setup status. See 3.2 Verifying Device Setup
Status.
2. Setup peer-to-peer printing. See 5.2 IPX Peer-to-peer Printing.
For printing via a NetWare print server:
1.
Verify the device setup status. See 3.2 Verifying Device Setup
Status.
2. Setup NetWare printing. See 4.3 NetWare Print Setup.
After setting up the printer, specify the port in the printer driver
properties, and execute the print command. For details about printing,
see your printer manual.