Konica Minolta PageScope - Manual (Page 35)

5 Peer-to-peer Print Setup
30
5.2.2 Configuring for IPX Peer-to-peer Printing by
Specifying the Device Manually
Perform the following steps to specify the device manually when
configuring for IPX peer-to-peer printing. See 5.2.1 Configuring IPX
Peer-to-peer Printing for the procedure you should use when the
device you want to configure is included in the
Device List on the P2P
Setup dialog box.
1. Select P2P Setup on the Setup menu to display the P2P Setup
dialog box.
You could also click the toolbar
button.
2. Click the Manual P2P button to display the P2P Manual Setup
dialog box.
3. Under IPX Connection , click the device specification method you
want to use to select it. The following methods are supported.
• Print Server Name Specify the device using its print server
name. (You could verify the Print Server
Name in NetWare setting. See 4.3.1 Setting
up the Print Server)
• Network Address Specify the device using its IPX address.
4. Type the device destination into the text box that becomes enabled
to the right of the method you select.