2 configuring for tcp/ip peer-to-peer, Printing by specifying the device manually – Konica Minolta PageScope User Manual
Page 32
5 Peer-to-peer Print Setup
27
5.1.2 Configuring for TCP/IP Peer-to-peer Printing by
Specifying the Device Manually
Perform the following steps to specify the device manually when
configuring for TCP/IP peer-to-peer printing. See 5.1.1 Configuring
for TCP/IP Peer-to-peer Printing for the procedure you should use
when the device you want to configure is included in the
Device List
on the
P2P Setup
dialog box.
1.
Select
P2P Setup
on the
Setup
menu to display the
P2P Setup
dialog box.
2.
Click the
Manual P2P
button to display the
P2P Manual Setup
dialog box.
3.
Under
TCP/IP Connection
, click the device specification method
you want to use to select it. The following methods are supported.
• Device Name (DNS name)
Specify the device using its host name.
• IP Address
Specify the device using its IP address.
• Hardware Address Specify the device using its network
interface hardware address.
4.
Type the device destination into the text box that becomes enabled
to the right of the method you select.