Kenwood NV 600 - Manual (Page 47)

47
Application section
CURSOR
ENTER
SET
4, ¢
Timer recording
1
Display the "Function" menu.
2
Select the message to be
displayed, "Timer Rec Off"
or “Timer Rec On”.
3
Select the message to be
displayed, "On”.
4
Perform the setting op-
eration in steps
4
to
5
under "Setting the timer
playback".
5
Select the input source to
be recorded.
6
Select a preset radio station.
7
Press the ENTER key.
8
After completing the set-
ting, set the power OFF.
÷ Select "Off" when you want to cancel the timer.
÷ "Tuner", "Video1" or "Video2" can be selected.
To return to the previous operation step in the middle,
select "Back" with the CURSOR key and press the SET
key. Select "Next" to advance to the next step.
Timer recording is used to record a source onto a
tape.
The TUNER or the component connected to the
Video1 or Video 2 input can be selected as the
source.
(This step is required only when the tuner
input is selected in the above.)
¢ 4
–P.CALL–
SET
¢ 4
–P.CALL–
SET
CURSOR
SET
CURSOR
SET
CURSOR
SET
Timer operation
÷ Audio is not output during timer recording.