Konica Minolta Copier 2223 - Manual (Page 33)

3-12 Copier Information
Copier Information
Automatic Settings
Initial Machine Settings
The machine settings listed below describe the initial condition of the
copier after warm up is completed. These initial settings will be
restored automatically if Auto Reset is set at 2 minutes, or if
AUTO is
pressed. ADF, AES, APS, and Sorter are service adjustable.
Print Quantity: 1
Magnification: 1.00
AES: ON
APS: ON
ADF: ON, if equipped
Sorter: OFF, if equipped
Special Features: OFF
Auto Reset None or 2 Minutes
If Auto Reset is activated by your service representative, the initial
machine settings will reset automatically after 2 minutes have elapsed
since manual selections were made. Otherwise, the initial machine
settings can be restored manually by pressing
AUTO on the control
panel.
Automatic Paper Selection (APS)
APS functions as a scanless operation. When the APS light is on, the
appropriate copy paper size feeds automatically for the following original
sizes on both the platen glass and RADF/ADF: 11”x17”, 8.5”x14”,
8.5”x11”, or 8.5”x11”R. ADF originals that are 5.5”x8.5” will be detected as
8.5”x11”. The next larger copy size will be selected for non-standard
originals; for example, an 8”x13” original will select 8.5”x14” copy paper
size. Platen originals that are 5.5"x8.5" will be detected as 8.5"x11"R. APS
can be set by service, as required. If there is no copy paper that is the
same size as the original, the display will flash indicating the necessary
paper size. When copy size is selected manually, APS will not function
and the APS indicator light will go out. APS can also be disabled by
pressing
BOOK COPY , raising the RADF/ADF, or changing the lens mode.