Kenwood TM-V7E - Manual (Page 49)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
43
■ Selecting Scan Resume Method
1 Select the desired band.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 8 (Scan Resume).
4 Press [SET] to toggle Time-Operated or
Carrier-Operated.
5 Press [MNU] again to exit Menu mode.
SCAN RESUME METHODS
Before using Scans other than Visual Scan, it’s necessary
to decide under what condition you want your transceiver to
continue scanning after detecting and stopping for a signal.
You can choose Time-Operated mode or Carrier-Operated
mode. The default is Time-Operated mode.
• Time-Operated mode
Your transceiver stops scanning after detecting a signal,
remains there for approximately 5 seconds, and then
continues to scan even if the signal is still present.
• Carrier-Operated mode
Your transceiver stops scanning after detecting a signal and
remains on the same frequency until the signal drops out.
There is a 2 second delay between signal drop-out and scan
resumption to allow time for any responding stations to begin
transmitting.
Note:
◆ Turning the Tuning control clockwise, or pressing Mic [UP] after a
signal that has stopped Scan drops out, causes scanning to resume
immediately upward.
◆ Turning the Tuning control counterclockwise, or pressing Mic [DWN]
after a signal that has stopped Scan drops out, causes scanning to
resume immediately downward.
VOL SQL
CALL CALL