Power-on message, Display demonstration mode – Kenwood TM-V7E User Manual
Page 75
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
69
POWER-ON MESSAGE
Each time you switch the transceiver ON, the factory-default
message appears and stays for approximately 2 seconds.
You can program your favorite message in place of
“KENWOOD”.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 2 (Front Panel).
3 Press [
s
s
s
s
s
]
, then select Item No. 2 (Power On Msg).
4 Press [SET].
•
The last digit blinks.
5 Press [VFO].
•
The cursor moves to the first digit.
6 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the first digit.
•
To skip by four characters when operating the above
control or keys, press [MHz]. Press [MHz] again to quit
this jump function.
7 Press [
s
s
s
s
s
]
.
•
The second digit blinks.
8 Repeat steps 6 and 7 to enter up to 7 digits.
•
After entering the 7th digit, pressing [
s
s
s
s
s
]
causes an error
beep to sound.
•
To re-enter the preceding digit, press [
t
t
t
t
t
]
.
•
To clear all digits and move back to the first digit, press
[VFO].
9 Press [SET] again to complete the setting.
10 Press [MNU] to exit Menu mode.
DISPLAY DEMONSTRATION MODE
By initiating this mode, various pre-programmed displays
appear. You still can normally use the transceiver in this
mode. Pressing buttons or microphone keys, or turning the
Tuning control restores the operating display immediately.
If there is no button/key entry or Tuning control adjustment
for approximately 12 seconds, the transceiver reverts back
to Demonstration mode.
Press [F]+[ ] to toggle the mode ON or OFF.
VOL SQL
CALL
CALL
VOL SQL
CALL
CALL
1
2