L-3 Communications Navigation Echosounder LAZ 5100 - Manual (Page 71)

Page 5-8
L-3 ELAC Nautik
Access to the SERVICE MENU is gained by pressing any CURSOR key. The word NO will change
to YES. Press the ENTER key and the SERVICE MENU, shown below, will appear.
The SERVICE MENU allows the service technician to access the following sub-MENUS:
• Channel 1 - allows selection of Draft, Trim, Blocking Depth, Frequency and
Location for the Channel 1 transducer.
• Channel 2 - allows selection of Draft, Trim, Blocking Depth, Frequency and
Location for the Channel 2 transducer, if fitted. If no 2nd Channel is
fitted, this MENU is not available
• Interfaces - allows selection of parameters for data transfer.
• Display 15 min altering the selection of the recording display time.
In order to set or alter the parameters for Channel 1, call up the CHANNEL 1 MENU, as
follows:
• Call up the SERVICE MENU as previously described
• CURSOR W (1x, to mark Channel 1)
• ENTER (1x, to call up the Channel 1 parameters MENU as seen below)
Draft 0.0 (0.0..29.9 m)
Trim 0.0 (0.0...4.9 m)
Blocking Depth 0.0 (0.0...2.9 m)
CHANNEL 1
Frequency 50 (28, 33, 38, 50, 100, 200, 210 kHz)
Location BOW (BOW, AFT, Stb., Pt.)
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Channel 1 >> To call up Channel 1 parameter MENU
Channel 2 >> To call up Channel 2 parameter MENU
Interfaces >> To call up interface parameter MENU
SERVICE
Display 15 min ON ON - OFF
Power adjust