L-3 Communications Navigation Echosounder LAZ 5100 - Manual (Page 74)

Page 5-11
L-3 ELAC Nautik
In order to set or alter the parameters for Channel 2, call up the CHANNEL 2 MENU, as
follows:
• Call up the SERVICE MENU as previously described
• CURSOR W(2x, to mark Channel 2)
• ENTER (1x, to call up the Channel 1 parameters MENU as seen below)
Proceed from here in exactly the same way as described for Channel 1 settings.
To call up the INTERFACE MENU. proceed as follows:
• Call up the SERVICE MENU as described previously
• CURSOR W (3x, to mark the word Interfaces)
• ENTER (1x, to call up the INTERFACES SUB-MENU)
The INTERFACE MENU shown below will appear.
External PC
Mode 8N1 (7E1, 7E2, 8N1, 8E1, 8N2, 8E2)
Baud 19200 (1200, 2400, 4800, 9600, 19200, 38400 Baud)
NMEA/DAZ 25
Mode 8N1 (7E1, 7E2,
, 8E1, 8N2, 8E2) 8N1
Baud 4800 (1200, 2400, , 9600, 19200, 38400 Baud) 4800
Rep. rate SLOW (SLOW, FAST)
INTERFACES
Protocol DPT/DBT (DPT/DBT, ELAC)
This menu allows the service technician to assign the interfaces to fit to other peripheral
equipment, e.g. a personal computer or digital slave indicators.