LevelOne WCS-2000 - Manual (Page 9)

For the WCS-2000, this disables the Wireless Interface, because
only one interface can be active. The LAN interface is
recommended for initial configuration.
The default Wireless settings for the WCS-2000 are:
Mode: Infrastructure
Channel: 11
ESSID: wireless
WEP: Disabled
3. Adjust the Antenna
On the WCS-2000, flip the top-mounted Antenna to the upright position to improve
wireless reception.
4. Power Up
Connect the supplied power adapter to the LevelOne IP Network Camera and power up.
Use only the power adapter provided. Using a different one may cause hardware damage.
4. Check the LEDs
• The Ready LED will turn on briefly, then start blinking. It will blink during startup, which
takes 15 to 20 seconds.
After startup is completed, the Ready LED should remain ON.
• The Active LED should be OFF.
It will flash when anyone is viewing live video.
• Either the LAN LED OR the Wireless LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
6