LevelOne WCS-2000 - Manual (Page 8)

5
2
Chapter 2
Basic Setup
This Chapter provides details of installing and configuring the LevelOne IP
Network Camera.
System Requirements
• To use the LAN interface, a standard 10/100BaseT hub or switch and network cable is
required.
• To use the Wireless interface on the WCS-2000, other Wireless devices must be compliant
with the IEEE802.11b specifications. All Wireless stations must use compatible settings.
Installation
Figure 3: LevelOne IP Network Camera Installation
1. Mount the Camera on the supplied Base and Stand.
Join the Base, stand and swivel connector to the camera, as shown in the diagram above.
2. Connect the LAN Cable
Connect the LevelOne IP Network Camera to a 10/100BaseT hub or switch.