Lexicon PCM 80 - Manual (Page 108)

Lexicon
4-12
PCM 80 User Guide
0.8 BandReject 4 ADJUST: FX Mix 0–100
Three independent modulators are used to sweep filters and pan the outputs of this
preset. The result is an effect with constantly changing tonal and spatial characteristics.
A touch of reverb adds some overall ambience. Use ADJUST to set the mix of filters and
reverb.
0.9 WaaPedalEko ADJUST: FeedBack 0–10
Wah-wah with echoes. Foot pedal is patched to filter cutoff. ADJUST controls echo
feedback.
1.0 RotorWaa ADJUST: Rate 0–10
A tempo controlled wah-wah effect. ADJUST controls the rhythm of the modulator.
1.1 Movable Echo ADJUST: Position 0-127
This preset is designed for use with either stereo or Surround mixes. It is a dual delay
effect that can be positioned anywhere between the center, side and rear channels.
ADJUST sets the position. 0 = center, 64 = side channels, 127 = rear channel.
1.2 Movable Hall ADJUST: Position 0–127
Like Movable Echo, this preset is designed for use with either stereo or Surround mixes.
It is a concert hall reverb effect that can be positioned anywhere between the center, side
and rear channels. ADJUST sets the position. 0 = center, 64 = side channels, 127 = rear
channel.
1.3 Go Away ADJUST: How Far? 0–127
Use this preset to take a stereo source and move it anywhere from in your face to far, far
away. Use ADJUST to move the source away from you. 0 = unprocessed stereo, 127 =
far away. As ADJUST is increased, EQ, reverb and stereo width are all changed to
produce the composite effect. This effect is compatible with stereo and Surround mixes.
1.4 Circular Pan ADJUST: Rate 0–100
Similar to Go Away, this preset sums the inputs to mono and uses the LFO to control EQ,
reverb and stereo width to pan the sound through a circular orbit. From right through
center,to left through rear, to right. As the sound approaches the center, it grows brighter,
louder and dryer. As it recedes towards the rear, it grows darker, softer and more
reverberant. In a Surround mix, the center and rear positions of the orbit will feed only the
center and rear channels of the mix. ADJUST controls the rate of the pan.
1.5 Spatial Hall ADJUST: Position 0–35
A multi-dimensional preset which changes as you increase or decrease the ADJUST
knob value. This preset is not mono compatible.
1.6 Rear of Hall ADJUST: Decay 0–60
This is a really huge space and you’re in the back of it. ADJUST changes the reverberation
characteristics, making it boomier.
1.7 Backstage ADJUST: How Far? 0–127
Remember what the concert sounded like from the green room? If you need to re-create
that ambience, this preset will take you there and let you wander around. Turn up ADJUST
to travel further from the stage until, finally, you’re out in the parking lot. The Soft Row
provides reverb parameters that will let you fine tune the the hall to fit your needs.
1.8 Steered Rear ADJUST: Decay 0–10
The Width parameter steers this plate effect from front to back after the AR releases
based on input level. ADJUST controls reverb decay. Due to the strong spatial positioning
at the end of the decay, this preset is not mono compatible.
Spatial Effects
(P2 1.1 – P2 2.4)
EQ Effects
(P2 0.0 – P2 1.0) cont'd.