Lexicon PCM 80 - Manual (Page 33)

2-15
Basic Operation
Control Mode
Matrix Location System Parameter Default Setting
Audio 0.0 Word Clock Internal 48kHz
0.1 Analog Lvl 100%
0.2 Digital Lvl 0%
0.3 Auto Lock Off
0.4 SCMS Multi Copy
0.5 Emphasis Bit Pass Thru
0.6 Output Level +4dBu
System 1.0 Edit Mode Go
1.1 Mix Mode Pgm
Global Mix Value 100% Wet
1.2 Tempo Mode Pgm
Global Tempo Value 120 BPM
1.3 Bypass Mode InputMute
Bypass Src Off
1.4 Pgm Bypass AllMute
1.5 Mem Protect On
1.6 Auto Load Off
1.7 Patch Update Delayed
MIDI 3.1 Receive OMNI
3.2 Transmit 1
3.3 Pgm Change On
Pgm+ Off
Pgm– Off
Map select 0
Chain MIDI
3.4 Automation Off
3.5 Footpedal None
Sw 1 None
Sw 2 None
ADJUST None
3.6 Int Clock Off
3.7 SysEx On
Device ID 0
3.9 Dump Speed Slow
Tempo Mode
Matrix Location System Parameter Default Setting
Tempo 0.2 Source Internal
Tap 1.3 Display On
4.1 Load
This control allows you to load your stored setup, restore the factory default
setup shown above, or load a setup from a Memory Card.
Row 4
Setup
4.0 Store
Control mode Audio, System, and MIDI parameter settings, along with two
settings from the Tempo matrix, comprise a "Setup." Five setups can be stored
in the unit, or on a Memory Card, allowing you to transport not only your effects,
but complete PCM 80 environments to another PCM 80. Press Store to initiate
the Setup Store function.
When the PCM 80 is shipped (or when you reinitialize the unit) default values are
assigned to these parameters. The following table shows the Setup parameters
along with the factory default setting of each parameter.