Lexicon PCM 80 - Manual (Page 32)

Lexicon
PCM 80 User Guide
2-14
To load a specific Program Chain, without sending the PCM 80 a MIDI Program
Change message, use ADJUST to display the desired chain number.
3.4 Automation
This control is provided for communication with one or more additional PCM 80s.
Select On to have values resulting from front panel operations sent out as SysEx
messages. Press Load/
✱ to select the ID (0-126 or All) of the target PCM 80(s).
3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST)
If Transmit is set to On these four controllers can transmit MIDI controller
messages. Press Load/
✱ to cycle through the controller selections. Use
ADJUST to select the MIDI Controller message to transmit.
3.6 Int Clock
You can choose to have the PCM 80 transmit MIDI Clock at the current tempo
rate by setting this control to On and Tempo mode Source (0.2) to Internal. If
this control is set to Off, MIDI Clock will not be transmitted.
3.7 SysEx
This control is provided for communication with one or more additional PCM 80s
or computer editor software. On (the default setting) allows SysEx messages
to be received by the PCM 80. Press Load/
✱ to select device ID (0-126 ).
3.8 Dump
Press Store to configure the PCM 80 to execute MIDI dumps of single effects,
banks, maps, chains, or setups.
3.9 Dump Speed
Turn ADJUST to select dump speeds of Slow, Medium or Fast to achieve
compatibility with the connected MIDI device.
MIDI Pgm Change
3.3 ✱ Chain 3