Lexicon PCM 80 - Manual (Page 30)

Lexicon
PCM 80 User Guide
2-12
2.2 Format
This control allows you to format a Memory Card for PCM 80 use. Press Store
and insert an unformatted card (or one you don't mind erasing). Make sure the
Write Protect latch on the card is set to Off. Press Store. The display will ask
"Are you sure?" (Press STORE). Press Store. The following display will appear
briefly.
This display allows you to assign a name (of 10 characters or less) to the card.
A blinking cursor indicates that a particular character is available for changing.
Use ADJUST to select the character you want in that position. Turn SELECT to
move the cursor to another character. Press Store to execute. The display will
ask "Are you sure?" (Press STORE). Press Store again to complete the
operation. Press any front panel button to cancel.
Format and name
memory card
Card Name: New Card
(press STORE)
The display will then change as shown below.
Row 3
MIDI
3.0 Reset
This control resets all patched parameters to their previously stored values.
When this control is activated, a MIDI "Reset All Controllers" message is also
transmitted on the current channel by the PCM 80.
3.1 Receive
Turn ADJUST to select OFF, 1-16, or OMNI for receipt of MIDI messages.
3.2 Transmit
Turn ADJUST to select OFF, or 1-16 for transmission of MIDI messages.
3.3 Pgm Change
This control specifies the PCM 80's response to incoming MIDI Program Change
messages. There are four selections available via ADJUST: On, Off, Map and
Chain.