Lathem Dukane 24A715 - Manual (Page 26)

Programming Functions
This section explains how to put the master clock in program mode and configure the
necessary functions to get the master clock running. For definitions of all functions, key
pad commands, and the bell test, see Section 3—Function List.
The master clock is normally in clock mode, displaying the date and time. To access pro-
gram mode, press [#] on the key pad. Pressing [*] stops programming so you can re-enter
a setting or quit.
Entering the Password
The administrative password provides access to both advanced functions and user functions.
The user password only provides access to user functions.
The factory-programmed user password is 000000, and can be changed (see page 3-6).
User passwords are explained further in the Master Clock User Guide, document
427-07-00047.
The factory-programmed administrative password is 332537, or DEALER (as spelled out
on a telephone key pad). It cannot be changed.
Note:
To keep the administrative functions secure, only give this guide to authorized personnel.
The following shows the key sequence to enter the password, and the resulting clock
display:
Administrative Password: User Password:
Press Display Press Display
[#] SELECT FUNCTION CODE [#] SELECT FUNCTION CODE
[0] [0] = ENTER PASSWORD [0] [0] = ENTER PASSWORD
[#] PASSWORD: 000000 [#] PASSWORD: 000000
[3][3][2][5][3][7] PASSWORD: 332537 [user password] PASSWORD: NNNNNN
[#] ADMINISTRATOR [#] PASSWORD ACCEPTED
PASSWORD ACCEPTED
The display returns to clock mode (the time and date) after a few seconds.
Notes:
A password expires after approximately five minutes. If the master clock starts block-
ing access to programming functions, re-enter the password.
To manually expire a password, see Securing the Setup on page 2-9.
2-2 24A715/24A715M Master Clock Installation Manual