Lathem Dukane 24A715 - Manual (Page 81)

Wiring the 12 Volt AC Out Terminals
The 12 Volt AC Out Terminals connect to a non-regulated 12V 250mA power source and
are used with the optional remote schedule selector (available from Lathem) when in
close proximity to the master clock. Contact Lathem Time Corporation for details.
—WARNING—
This circuit is not fused separately.
Attaching devices with a higher current
load may damage the master clock.
Strain Relief for the Communications Cable
Attach the two wire tie wraps included in the installation kit to the terminal block as
shown to provide strain relief to the communications cable. Use any two empty positions.
24A715/24A715M Master Clock Installation Manual C-7
Figure C-10
Example of Cable Strain Relief