Basic sensor installation – Linear DVS-2400 User Manual

Page 16

Advertising
background image

14

✦ Each accessory sensor is packaged with its own

set of installation instructions specifi c to the model
of sensor.

Refer to the sensor's instructions for details on

installing, operating, and testing of the sensor.

✦ Following are basic instructions for installing two

popular DVS-2400 accessories: The Model DXS-10
Wireless Remote Keypad and the Model DXS-31 or
DXS-32 Door/Window Transmitters.

DXS-10 WIRELESS KEYPAD

✦ The DXS-10 is used to remotely command the

Console.

✦ The keypad can be simply set on a table or

mounted to a fl at surface.

TABLE-TOP USE

✦ Four anti-mar pads are provided as a scratch

deterrent “feet” for the keypad.

NOTE: Do not use the adhesive “feet” if the keypad

is going to be wall mounted.

1. Peel off the adhesive tape backing on the pads and

stick them to the back of the keypad.

✦ The wireless keypad can be used as a portable

keypad. Because of the hourly supervisory
transmissions, if the unit is taken out of range from
the Console for more than eight hours, the Console
will indicate “radio trouble” for the keypad. The
keypad's sensor number can be programmed for
“non-supervised” if required. See the “Advanced
Programming” section of this manual.

WALL MOUNT USE

✦ The wireless keypad can be wall mounted in a

convenient location.

1. Open the keypad by inserting a small screwdriver in

one of the top slots in the keypad case. Gently twist
the screwdriver until the case pops open.

2. Attach the rear case to the wall using the two

screws provided.

NOTE: For best signal transmission, the keypad

should be mounted at least three feet above
ground level.

3. Hook the top edge of the keypad case together and

snap the keypad onto the rear case.

WARNING: The wireless keypad is designed for

indoor use only.

7.

BASIC SENSOR INSTALLATION

FROM TOP OF CASE TWIST
SCREWDRIVER BETWEEN
CASE HALVES UNTIL IT
POPS OPEN

CONNECT BATTERY
TO BATTERY CLIPS

USE THE FOUR SCRATCH
DETERRENT PADS PROVIDED
FOR TABLE-TOP USE

ATTACH REAR CASE TO WALL
WITH THE TWO SCREWS PROVIDED

MOUNT AT A CONVENIENT
LOCATION NEAR PRIMARY
ENTRY/EXIT DOOR

Advertising