Linear DVS-2400 - Manual (Page 35)

33
GENERAL COMMUNICATOR OPTIONS
COMMUNICATOR ENABLE
✦ The factory setting for the Console disables
the communicator. If the system is going to be
a non-monitored, local alarm only, leave the
communicator disabled.
STEP #107 If the system is going to be monitored by a
Central Station, enable the communicator with this
programming step.
2-WAY AUDIO
✦ When the Model VB-2 voice module is installed, the
communicator can provide 2-way audio capability.
✦ The audio module can be programmed for
listen-only, 2-way manual operation (using a
pushbutton telephone at the Central Station), and
2-way full duplex hands free operation.
✦ Refer to the VB-2 installation instructions for details
on operating the audio module.
✎ NOTE: The Model VB-2 digital voice response
module must be installed for this option to
function.
✦ The factory setting for the VB-2 audio module is OFF.
STEP #76 The audio module can be set for (1) listen-only, (2)
2-way manual, (3) 2-way full duplex using this step.
✎ NOTE: For safety, 2-way audio will not activate if
the system is disarmed with the duress code.
✎ NOTE:Units programmed for two-way duplex can
still be controlled manually by pressing the “1” or
“3” key. In addition, the Central Station can return
the unit to two-way duplex by pressing the “8” key.
VOICE RESPONSE
✦ The Console can be programmed to allow the
speaker to play audio produced by the VB-2 digital
voice response module.
✦ This selection can also be used when a remote
speaker is connected to the Console.
✦ The factory setting is to disable the speaker from
playing voice module audio.
STEP #78 The Console can be programmed to enable voice
module audio using this step.
✎ NOTE: Turning voice response OFF with this
programming step will only effect the audio produced
by the voice module. It will not stop the Console’s
speaker from sounding local sirens and tones.
✎ NOTE: A Model VB-2 digital voice response module
must be installed for this option to function.
REMOTE LOCKOUT
✦ The factory setting for the communicator allows
remote connection to the Console with Linear's
RA-2400 Remote Access Software and a modem
(unlocked).
STEP #100 The Console can be programmed to not answer
incoming calls, thereby, not allowing remote access
(locked) using this step.
0
7 PRS
HOME
AWAY
0 FOR COMMUNICATOR OFF
1 FOR COMMUNICATOR ON
PROGRAMMING STEP #107
PROGRAM
STORE PROGRAM
1
7 PRS
6 MNO
HOME
AWAY
0 FOR NO AUDIO MONITORING
1 FOR LISTEN-ONLY
2 FOR 2-WAY MANUAL
3 FOR 2-WAY FULL DUPLEX
PROGRAM
STORE PROGRAM
PROGRAMMING STEP #76
7 PRS
8 TUV
HOME
AWAY
0 FOR NO VOICE RESPONSE
1 FOR VOICE RESPONSE
PROGRAMMING STEP #78
PROGRAM
STORE PROGRAM
0
0
HOME
AWAY
0 FOR UNLOCK
1 FOR LOCK
PROGRAMMING STEP #100
PROGRAM
STORE PROGRAM
1