Test mode – Linear DVS-2400 User Manual

Page 22

Advertising
background image

20

TEST MODE

✦ Even though this is a self-monitoring supervised

system, the National Burglar and Fire Alarm
Association recommends that all security systems
should be tested manually on a regular basis.

1. The Console must be in Off Mode before switching

to Test Mode.

2. Switch the Console into Test Mode by entering a

user code and pressing TEST.

When the system is switched to the Test Mode, the Console

will sound a “Gong” and four “Beeps”.

3. Holding down the TEST button in Test Mode will light

all of the Console’s indicators.

The sensor status indicators will fl ash for each sensor

programmed into the Console.

4. Go to each sensor and press its test button or open

and close the protected opening.

5. To test the wireless keypad, press the wireless

keypad’s

key.

The Console will make a “Bing” sound as each sensor is

tested, followed by 1-3 beeps indicating signal strength with
3 beeps being the strongest signal.

As each sensor is tested, the sensor status indicator for the

sensor will stop fl ashing and return to showing the current
status of the sensor.

6. Continue testing until there are no fl ashing sensor

status indicators.

SENSOR OPERATION IN EACH CONSOLE MODE

SENSOR TYPE

OFF MODE

CHIME MODE

HOME MODE

AWAY MODE

AUTOMATION

ACTIVATES AND DEACTIVATES THE AUTOMATION OUTPUT

EMERGENCY

ARMED 24-HOURS - TRIGGERS EMERGENCY ALARM

PANIC

ARMED 24-HOURS - TRIGGERS SILENT PANIC ALARM

FIRE

ARMED 24-HOURS - TRIGGERS FIRE ALARM

PERIMETER

DEACTIVATED

CHIME

INSTANT BURGLARY ALARM

EXIT/ENTRY

DEACTIVATED

CHIME

DELAYED BURGLARY ALARM

INTERIOR

DEACTIVATED

DEACTIVATED

DEACTIVATED

INSTANT BURGLARY ALARM UNLESS

ACTIVATED DURING AN ENTRY

DELAY, THEN IT IS DELAYED

CHIME

CHIME

2-BUTTON ARM/DISARM (LEFT)
2-BUTTON AUTOMATION (RIGHT)
EMERGENCY (BOTH BUTTONS)

LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †

IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡

LEFT BUTTON SWITCHES SYSTEM TO OFF MODE ‡

2-BUTTON ARM (LEFT)
2-BUTTON DISARM (RIGHT)
EMERGENCY (BOTH BUTTONS)

LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †

IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡

RIGHT BUTTON SWITCHES SYSTEM TO OFF MODE ‡

ENVIRONMENTAL

ARMED 24-HOURS - TRIGGERS ANNUNCIATION ONLY

INTERIOR HOME

DEACTIVATED

DEACTIVATED

INSTANT BURGLARY ALARM

NOTE: If the Console is left unattended in Test

Mode, it will automatically switch back to Off Mode
after three minutes.

✦ When directly connecting (without a telephone

line) to the DVS-2400 with the RA-2400 remote
access software (Version 1.3 or later), press the
EMERGENCY key while in Test Mode to cause the
Console to connect to the modem.

CAN BE HOME MODE USING PROGRAMMING STEP 50

‡ CAN BE CHIME MODE USING PROGRAMMING STEP 51

Console Zone Table

START IN OFF

YOUR
USER
CODE

DONE

1 GONG
& 4 BEEPS

(OPTIONAL)

TEST MODE

TEST

Advertising