Troubleshooting (cont’d.) – LOREX Technology Lorex Digital Video Surveillance Recorder lh1 10 User Manual

Page 162

Advertising
background image

148

Troubleshooting

Troubleshooting (cont’d.)

Error

Possible Causes

Solutions

• Mouse not detected
by system

• Mouse cable is not firmly
connected to the system

• Firmly connect the mouse cable to the USB Mouse
port on the front panel

• Mouse is not connected to the
system

• System needs to be reset

• Power off the system (disconnect power cable).
Firmly connect a USB mouse to the USB Mouse port
on the front panel of the system. Reconnect the
power cable to the DC 12V port on the rear panel.

• There is no picture
on selected channels
/ camera picture is
not being displayed

• Camera cables are loose or
have become disconnected

• Check the camera video cable and connections
• Disconnect and reconnect the cable at the system
and at the camera
• Try moving the camera to another channel or use
another cable

• The image on the
DVR appears, but
does not have sound

• Audio cables are loose or have
been disconnected

• Check the AUDIO connections to the DVR

• Audio channels are disabled in
the system menu

• Check the Configurations: Main Menu

>

Record. In

the Audio drop-down menu, select Enable, and click
Apply

• Volume on external speakers
(not included) is low or off

• Increase volume on external speakers (not
included)

• The system beeps
at startup

• The beep at startup is normal

• The system beeps
during motion
detection

• Motion detection is enabled, but
the alarm buzzer is activated

• Open the Main Menu and click DEVICE

>

Alarm

• In the Buzzer drop-down, select Off. Click apply.

• I am not receiving
email notifications

• Email notification is disabled

• Open Main Menu

>

Device

>

Alarm. Click the Email

Setup button. In the Email drop-down menu, select
Default. Enter the Sender and receiver email. Click
Apply.

• Default setting is disabled, but
you have not entered your own
SMTP information

• If you want to use your own SMTP server, deselect
the Default box, and enter your SMTP Server
address, Port, User name, and Password in the
respective fields

Advertising