Tilting, Lifting, Installation – Lincoln Electric CLASSIC I SVM134-A User Manual

Page 10: Pre-operation engine service, Warning

Advertising

STACKING

Classic I machines CANNOT be stacked.

TILTING

Place the machine on a secure, level surface whenev-
er you use it or store it. Any surfaces you place it on
other than the ground must be firm, non-skid, and
structurally sound.

The gasoline engine is designed to run in a level posi-
tion for best performance. If you do operate it at a slight
angle, be sure to check the oil regularly and keep the
oil level at the FULL mark as it would be in its normal
level condition. Also, fuel capacity will be a little less at
an angle.

LIFTING

The Classic I weighs 1370 lb./621 kg.

A lift bail is

provided for lifting with a hoist.

FALLING EQUIPMENT can
cause injury.

Do not lift this machine using lift bail if
it is equipped with a heavy accessory
such as a trailer.

Lift only with equipment of adequate lifting capacity. Be
sure machine is stable when lifting.

HIGH ALTITUDE OPERATION

It may be necessary to derate welder output at higher
altitudes. Some engine adjustment may be required.
Contact a Continental Service Representative.

PRE-OPERATION ENGINE SERVICE

Read and understand the information about the gaso-
line engine in the

Operation and Maintenance sec-

tions of this manual before you operate the Classic I.

Keep hands away from the engine muffler or HOT
engine parts.

• Stop the engine when fueling.

• Do not smoke when fueling.

• Remove the fuel cap slowly to release pressure.

• Do not overfill the fuel tank.

• Wipe up spilled fuel and allow the fumes to clear

before starting the engine.

• Keep sparks and flame away from the fuel tank.

OIL

The Classic I is shipped with the engine
filled with SAE 10W-30 oil. This should be

fine for most ambient operating temperature condi-
tions. See the engine operation manual for specific
recommendations. CHECK THE OIL LEVEL BEFORE
YOU START THE ENGINE. This is an added precau-
tion. When full, the oil level should be up to but not over
the FULL mark on the dipstick. If it is not full, add
enough oil to fill it to the full mark. DO NOT overfill.

For more oil fill and service information, see the
Maintenance section of this manual.

FUEL

Fill the fuel tank with clean, gasoline only.
The Classic I has a 15 gallon (57 liter) fuel
tank with a top fill and fuel gauge mounted
on the control panel. See the

Operation

and

Maintenance sections of this manual

for more details about fuel.

BATTERY CONNECTIONS

The Classic I is shipped with the negative battery cable

disconnected.

Before you operate the

machine, make sure the
IGNITION switch is in the OFF position and

attach the disconnected cable securely to the battery
terminal. If the battery is discharged and won't start the
engine, see the battery charging instructions in the
Maintenance section.

INSTALLATION

A-4

CLASSIC I

WARNING

–