See the, Accessories, Module - see the – Lincoln Electric CLASSIC I SVM134-A User Manual
Page 26: Options/accessories, Warning
OPTIONS/ACCESSORIES
The following options/accessories are available for your
Classic I from your local Lincoln Distributor.
Trailer (K768) - For in-plant or yard towing at speeds
under 10 m.p.h. Not intended for highway towing.
Trailer (K780) - Two-wheeled trailer with brakes, lights,
and fenders. For highway use, consult applicable fed-
eral, state and local laws.
Trailer (K913) - Two-wheeled trailer for in-plant and
yard towing. For highway use, consult applicable fed-
eral, state, and local laws. Various hitches and acces-
sories are available.
Power Plug Kit (K802-A) - Provides auxiliary plug for
115VDC receptacle.
CV Adapter - (K384) - Provides constant voltage out-
put for semiautomatic welding. (For K6090 through -4
only.)
Wire Feed Module - (K623-1) - Provides constant volt-
age output for semiautomatic welding. For LN-25 wire
feeder. (For K6090-5 and above.)
Linc Thaw™ Control Unit (L2964-1) - Includes meter
and fuses to protect the welder when thawing frozen
water pipes.
PIPE THAWING IS NOT a CSA approved procedure.
If not done properly, it can result in fire, explosion,
damage to wiring which may make it unsafe, dam-
age to pipes, burning up the welder, or other haz-
ards.
Do not use a welder to thaw pipe before reviewing
Lincoln Bulletin E695.1 (dated October 1987 or later.)
Accessory Kit (K702) - Includes the following:
• Electrode cable
• Work cable
• Headshield
• Work clamp
• Insulated electrode holder
Remote Control - (K888-4) - Includes a control box
with 100 ft. (30.5 meters) of cable. Allows output to be
controlled remotely. K888-3 has only 25 ft. (7.6 meters)
of cable. (For K6090 through -4 only.)
Remote Control Kit - (K924-1) - Includes a control box
with 100 ft. (30.5 meters) of cable. Allows output to be
controlled remotely. (For K6090-5 and above.)
SEMIAUTOMATIC WELDING ACCESSORIES
LN-25 Wire Feeder - This portable wire feeder is capa-
ble of CC/CV wire feed welding.
NOTE: Gas-shielded welding requires a Magnum Gun.
Gasless welding requires an Innershield Gun.
ACCESSORIES
C-2
C-2
CLASSIC I
WARNING