Vlan settings – Linksys VOICE SYSTEM SPA 900 SERIES User Manual
Page 113
5-8
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
System Tab
VLAN Settings
Note
None of the following parameters apply to the SPA901.
Secondary DNS
DNS server used by Linksys IP phone in addition to DHCP supplied DNS servers if
DHCP is enabled; when DHCP is disabled, this is the secondary DNS server.
Defaults to 0.0.0.0.
DNS Server Order
(Not applicable to SPA901)
Specifies the method for selecting the DNS server. The options are Manual,
Manual/DHCP, and DHCP/Manual.
DNS Query Mode
Do parallel or sequential DNS Query. With parallel DNS query mode, the Linksys IP
phone sends the same request to all the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the Linksys IP phone.
Defaults to parallel.
Syslog Server
Specify the syslog server name and port. This feature specifies the server for logging
Linksys IP phone system information and critical events. If both Debug Server and Syslog
Server are specified, Syslog messages are also logged to the Debug Server.
Debug Server
The debug server name and port. This feature specifies the server for logging Linksys IP
phone debug information. The level of detailed output depends on the debug level
parameter setting.
Debug Level
The debug level from 0-3. The higher the level, the more debug information is generated.
Zero (0) means no debug information is generated. To log SIP messages, you must set the
Debug Level to at least 2.
Defaults to 0.
Primary NTP Server
(Not applicable to SPA901)
IP address or name of primary NTP server.
Secondary NTP Server
(Not applicable to SPA901)
IP address or name of secondary NTP server.
Field
Description
Enable VLAN
Enable this parameter if the switch to which the Linksys IP phone is connected uses
VLAN tagging.
VLAN ID
Enter the VLAN tag for the VLAN to which the Linksys IP phone is assigned. This should
be the same VLAN to which the SPA9000 is assigned.
Enable CDP
Enables or disables Cisco Discovery Protocol (CDP.
Defaults to Yes.
Field
Description