Linksys VOICE SYSTEM SPA 900 SERIES - Manual (Page 96)

4-9
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 4 SPA900 Series LCD Command Reference
8 Voice Mail
• Offset—+/-H:m:s
To enter a / or : use the * (star) key. For offset value, use the * (star) key for + and the # (pound) key for
-. After entering the required values, press the save soft key, to save the information into the phone
memory. Erase mistaken numbers, one at a time using the delChr soft key.
8 Voice Mail
Shortcut: Setup, 8, voicemail_number , save
To set the number to call voicemail, press Setup and then press 8, or scroll down until the selection is
highlighted and press the select soft key.
When the display prompts for the Voice Mail Number, enter the number as if dialing the number. Erase
mistaken numbers, one at a time using the delChr soft key. Then press the save button to save the
number. After the number is saved, use the mailbox key on the right hand side of the phone (this is the
third button up from the Setup button) to dial the mailbox.
9 Network
To view or modify network parameters, press the Setup button and then press 9, or scroll down until
Network is highlighted and then press the select soft key. This menu displays the IP network
configuration settings.
The following options are available from the Network menu:
• 9.1 DHCP
• 9.2 Current IP Address
• 9.3 Host Name
• 9.4 Domain
• 9.5 Current Subnet Mask
• 9.6 Current Gateway
• 9.7 Enable Web Server
• 9.8 Non DHCP IP Address
• 9.9 Non DHCP Subnet Mask
• 9.10 Non DHCP Default Route
• 9.11 Non DHCP DNS 1
• 9.12 Non DHCP DNS 2
• 9.13 Non DHCP NTP Server 1
• 9.14 Non DHCP NTP Server 2
• 9.15 Multicast Address
• 9.16 Enable VLAN
• 9.17 VLAN ID
• 9.18 CDP