Increased. see stall factor number adjustment, Stall factor number adjustment, See stall factor number adjustment – Lincoln Electric POWER MIG SVM165-A User Manual
Page 60: See stall, Factor number adjustment, Troubleshooting & repair, Caution
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
TROUBLESHOOTING & REPAIR
F-14
F-14
POWER MIG 350MP
PUSH PULL WIRE FEEDING PROBLEMS
STALL FACTOR - an adjustment to the Power Mig 350MP that allows the welder to adjust the maximum amount
of power going to the rear drive motor. The purpose is to send only enough power to the rear drive motor to pull
the wire off the spool and get the wire up the torch liner.
STALL FACTOR NUMBER ADJUSTMENT
1. Turn the Power Mig 350MP off.
2. Hold the Push-pull torch trigger in and turn the power back on. Continue to hold the trigger in while machine
powers up.
3. Once the machine displays “SF” in the left display and a number 5 to 35 in the right display the trigger can be
released.
4. Use the volts /trim knob to adjust the Stall Factor Number.
5. Once the Stall Factor Number is adjusted push the select switch up.
6. The display should scroll the word “SAVEd” if the number was changed. The display will scroll “no CHANGE”
if the SF number was not changed.
7. The machine should automatically switch back to normal operation after it is done saving the SF number.
POWER MIG 350MP “CLEAR ALL” PROCEDURE
1. Hold “select” switch up while powering up machine.
2. Release “select” switch when displays show “PrESSPin”.
3. Turn the right “encoder knob” until displays show “CLrAll”.
4. Toggle the “select” switch up and release.
5. Machine will reset itself.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely,
contact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
1-888-935-3877.
CAUTION