Lexmark 1500 Series - Manual (Page 30)

Note: Photo cards require more drying time. Remove each photo card as it exits, and allow it to dry to avoid ink
smudging.
Loading transparencies
You can load up to 50 transparencies at a time.
1 Load transparencies with the rough side facing you. If the transparencies have a removable strip, each strip
should face away from you and down toward the printer.
2 Make sure:
• The transparencies are loaded in the center of the paper support.
• The paper guides rest against the edges of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid
ink smudging.
Loading iron-on transfers
You can load up to 10 iron-on transfers at once, but you will achieve best results loading them one at a time.
1 Load iron-on transfers with the print side of the transfer facing you.
2 Make sure:
• You follow the loading instructions that came with the iron-on transfers.
• The transfers are loaded in the center of the paper support.
• The paper guides rest against the edges of the transfers.
Loading custom-size paper
You can load up to 100 sheets of custom-size paper at a time.
1 Load paper with the print side facing you.
2 Make sure:
• The paper size fits within these dimensions:
Width:
– 76.0–216.0 mm
– 3.0–8.5 inches
Length:
– 127.0–432.0 mm
– 5.0–17.0 inches
• The stack height does not exceed 10 mm.
• The paper is loaded in the center of the paper support.
• The paper guides rest against the edges of the paper.
30