Panasonic Web-Server FP - Manual (Page 68)

FP Web-Server V2.11 6.1 Email Functions of the FP Web-Server
57
The communication parameters for RS232C to the PLC for email handling is defined in
Configurator's tab "Config".
Open the "Email" tab in the Configurator for all further settings:
"Email sending enable":
This setting is used to turn the email function of the FP Web-Server on or off. Disable this
checkbox if the email function is not used. This saves the FP Web-Server's memory.
[Email Server]
Refer to the online help under the keyword Email Server Settings for detailed information.
"Email server address":
The name of the server or the IP address configured in the Email Server Settings dialog is
shown here.
"Email sender address":
The email sender's address (email address of the PLC, i.e. the FP Web-Server) is defined here.
It must be known to the SMPT email server.
Always enter the email sender's address without <> characters!
Japanese characters are not allowed, nor are ASCII characters that contain umlauts.
[Internet Email: Dial-up and ISP settings]
For detailed information refer to the section Internet Email Settings (see page 130).