Pelco Dx8000 - Manual (Page 75)

C623M-C (3/05) 75
SETTING UP AUDIO OUTPUT
The DX8000 delivers a line-level monaural signal through a standard 0.125-inch phone jack on the rear panel of the DVR. It is recommended that
the audio output of the DX8000 be connected to an amplifier in order to boost the output signal to a level that is sufficient to drive a speaker.
Figure 85 illustrates an example of an audio output configuration.
1. Connect the audio output of the DX8000 to an audio amplifier.
2. Connect the audio amplifier to a speaker.
Figure 85. Audio Output Configuration Example
NOTE: Some speaker systems integrate both amplifiers and speakers in a single unit. Such a system can be connected directly to the
audio output of the DX8000 without the need for external amplification.
NOTE: Use an audio cable with a 0.125-inch miniature male phone plug on one end to connect to the audio output of the DX8000. Ensure
that the opposite end of the cable has the appropriate connectors for connection to your amplifier.
SPEAKER
MINI MALE PHONE PLUG
CRT CRT
IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8 IN9 IN10 IN11 IN12 IN13 IN14 IN15 IN16
OUT16 OUT15 OUT14 OUT13 OUT12 OUT11 OUT10 OUT9 OUT8 OUT7 OUT6 OUT5 OUT4 OUT3 OUT2 OUT1
ALARM INPUTS RELAY OUTPUTS
1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16
1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16
CRT
AUDIO AMPLIFIER