Panasonic KX-TC1871ALB - Manual (Page 92)

“ Before Requesting Help
92
Problem
The answering system is on,
but incoming messages are
not recorded.
You cannot listen to the
recorded messages.
“ Message full ” is
displayed and the ANSWER
ON indicator flashes rapidly,
and no new messages are
recorded.
You cannot operate the
answering system at the
base unit.
You cannot operate the
answering system from a
touch tone phone.
You cannot operate
the answering system with
the handset.
Cause and Remedy
≥ The recording time is set to “Greeting
only”. Select “1 minute” or “3 minutes”
(p. 27).
≥ Memory is full. Erase some, or all, of
the messages (p. 69).
≥ Make sure that the unit is in the standby
mode.
≥ Memory is full. Erase some, or all, of
the messages (p. 69).
≥ The handset user is operating the
answering system. Wait until the
IN USE/CHARGE indicator light goes
out.
≥ Make sure you enter the correct remote
code.
≥ The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
≥ The answering system is off. Turn it on
(p. 81).
≥ Someone is operating the answering
system.
≥ You are too far from the base unit.
Move closer to the base unit.
≥ The unit is recording a message.
To answer the call, press
(TALK) .
Answering System
PQQX12877ZA-6 00.8.23 10:54 AM y [ W 92