Audio adjustments, Operation modes 43, Operation mode marks 43 – Pioneer FH-P9200MP User Manual

Page 43: Way network mode, Standard mode, Adjusting the audio easily 43, Adjusting the audio finely 43, Operation modes

Advertising

Operation modes

This unit features two operation modes: the 3-

way network mode (NW) and the standard

mode (STD). You can switch between modes

as desired. Initially, the DSP setting is set to

the standard mode (STD). (Refer to Switching

the DSP setting mode on page 6.)

! The 3-way network mode (NW) lets you cre-

ate of a 3-way multi-amp, multi-speaker sys-

tem with separate speakers for

reproduction of high, middle and low fre-

quencies (bands), each driven by a dedi-

cated power amp. The 3-way network mode

provides network and time alignment func-

tions, two functions essential for a multi-

amp, multi-speaker system, to enable pre-

cise control over settings for each fre-

quency range.

! The standard mode (STD) lets you create a

4-speaker system with front and rear speak-

ers, or a 6-speaker system with front and

rear speakers and subwoofers. The stan-

dard mode provides a sound field control

function offering an easy way to recreate

realistic sound fields in your car.

Important

! When no power is supplied to this unit be-

cause of an exchange of the car battery or si-
milar, the microcomputer of this unit is
returned to its initial condition. If this hap-
pens, all memorized adjusted audio settings
are erased. When you have completed audio
setting adjustment, be sure to record the set-
tings on page 70.

Operation mode marks

This manual uses the following marks to make

the description clear.

: This mark indicates a function only in

NW mode or an operation in NW mode.

: This mark indicates a function available

only in STD mode or an operation in STD

mode.

! The functions and operations which do not

carry either mark are commonly used in

the NW and STD modes.

3-way network mode