Pioneer FH-P9200MP - Manual (Page 58)

Selecting the digital
attenuator
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 With the source turned off, press
and hold.
2Press D.ATT to select the digital at-
tenuator mode.
3 Press the corresponding button to se-
lect the digital attenuator level.
Button Level
LOW Low
HIGH High
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound turns off, MUTE or ATT is dis-
played and no audio adjustments, except
volume control, are possible.
! Operation returns to normal when the
phone call is ended.
1 With the source turned off, press
and hold.
2Press MUTE.S to select the telephone
muting/attenuation mode.
3 Press MUTE.S to select the desired set-
ting.
Each press of MUTE.S selects settings in the
following order:
TEL mute (muting) 10dB ATT (attenuation)
 20dB ATT (attenuation)
20dB ATT has a stronger effect than
10dB ATT.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 With the source turned off, press
and hold.
2Press NEXT and then press FMstep to
select the FM tuning step mode.
3 Press the corresponding button to se-
lect the desired tuning step.
Button Tuning step
50K 50 kHz
100K 100 kHz
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
Initial Settings
En
58
Section
12