Pioneer FH-P9200MP - Manual (Page 57)

Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
The initial settings menu has the following
functions:
REV (reverse mode)F.DEMO (feature demo)
AUX (auxiliary input)D.ATT (digital at-
tenuator)MUTE.S (telephone muting/at-
tenuation)FMstep (FM tuning step)
AMstep (AM tuning step)
1 Rotate SOURCE until the unit turns off.
2Press and hold to enter the initial-
settings menu.
When the source is off, you can check the lo-
cation of by turning on the feature demo.
# To cancel initial settings, press BAND.
Using reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
You can turn the reverse mode on or off.
1 With the source turned off, press
and hold to select the reverse mode.
2Press REV to turn the reverse mode on.
ON appears in the display.
# To turn the reverse mode off, press REV
again.
Using the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
You can turn the feature demo on or off.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.
1 With the source turned off, press
and hold.
2Press F.DEMO to select the feature
demo mode.
3 Press F.DEMO to turn the feature demo
on.
ON appears in the display.
# To turn the feature demo off, press F.DEMO
again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 With the source turned off, press
and hold.
2Press AUX to select the AUX mode.
3 Press AUX to turn AUX on.
ON appears in the display.
# To turn AUX off, press AUX again.
Initial Settings
En
57
English
Section
12