Pioneer FH-P9200MP - Manual (Page 66)

Message Cause Action
Error check
MIC
Microphone is
not connected.
Plug the supplied
microphone se-
curely into the
jack.
Error check
front SP, Error
check FL SP,
Error check FR
SP, Error check
RL SP, Error
check RR SP,
Error check
SW
The microphone
cannot pick up
the measuring
tone of any
speaker.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
Error check
noise
The surrounding
noise level is too
high.
! Stop your car in
a place that is as
quite as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.
A.TA&EQ una-
vailable
The operation
mode set to NW
mode.
The auto TA and
EQ function does
not work in NW
mode.
CD player and care
! Use only CDs that have either of the two
Compact Disc Digital Audio marks as
shown below.
! Use only normal, round CDs. If you insert ir-
regular, non-round, shaped CDs they may
jam in the CD player or not play properly.
! Check all CDs for cracks, scratches or
warped discs before playing. CDs that have
cracks, scratches or are warped may not
play properly. Do not use such discs.
! Avoid touching the recorded (non-printed
side) surface when handling the disc.
! Store discs in their cases when not in use.
! Keep discs out of direct sunlight and do
not expose the discs to high temperatures.
! Do not attach labels, write on or apply che-
micals to the surface of the discs.
! To clean dirt from a CD, wipe the disc with
a soft cloth outward from the center of the
disc.
! If the heater is used in cold weather, moist-
ure may form on components inside the
CD player. Condensation may cause the CD
player to not operate properly. If you think
that condensation is a problem turn off the
CD player for an hour or so to allow the CD
player to dry out and wipe any damp discs
with a soft cloth to remove the moisture.
! Road shocks may interrupt CD playback.
Additional Information
En
66
Appendix