Panasonic PV-D4761 - Manual (Page 17)

17 [email protected]
*Important: If a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.
Initial Setup
(Connection)
Press CH
to start “CHANNEL/CLOCK AUTO SET.” 6
Settings are performed automatically.
Case 1 Setup complete...
Press CH
to exit.
Case 2 Setup Incomplete...
Press ACTION
to display Manual
Clock Set screen.
7
Press
to select the month
and
press SET.
In the same manner,
select and set the
date, year, time, and
DST (daylight saving
time).
Press ACTION twice
to start CLOCK
and exit.
5
Press
to select the same channel as the Cable
Box or DSS Receiver output channel.
Press SET to enter.
Use when moving DECK to new
location, or if a mistake was made in
the Initial Setup section.
• Make sure a tape is not inserted in
DECK.
Reset All Memory Functions
Turn DECK
Power on.
2
1
3
Press and hold both PLAY and
CHANNEL on DECK for more
than 5 seconds.
• The power shuts off.
• Please ignore “NO CASSETTE”
warning.
Do “Initial Setup” on p. 16.
SELECT : SET : SET
EXIT : ACT I ON
SELECT CONNECTION
CABLE / DSS BOX OUTPUT CH
CH CH 0 0 1
CABLE / DSS BOX VCR TV
CHANNEL / CLOCK AUTO SET
CONNECT ANTENNA CABLE
LOCAL PBS CH THEN. . .
AND I F YOU USE A CABLE
BOX, TUNE I T TO YOUR
PLE ASE PRESS CH UP KEY
1 / 4 / 20 01 THU 12 : 00PM
END : CH UP KEY
DST : ON
SETT I NG : CH 02
AUTO CLOCK SET
COMPLETED
AUTO CLOCK SET IS
I NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACT I ON KEY
DST : ON
SE SE LE CT MONTH TH
1 / / :
SELECT :
SET :SET
EXIT : ACT I ON
- - - - - - - - -- - - - - - - -- - - - - -
SET CLOCK
SET : SET BACK :
START : ACT I ON
DST : ON
1 / 4 / 2001 2001 THU THU 12 12: 0 0 PM
SET SET CO COMPLETED
- - - - - - - - -- - - - - - - -- - - - - -
SET CLOCK