Panasonic PV-D4761 - Manual (Page 27)

27 [email protected]
Auto VCR Plus+ System Channel Setup (Part 2)
Press
to select channel map for
your area and
press SET.
Before you perform the following steps, you should have:
• completed “Auto VCR Plus+ System Channel Setup (Part 1)” on p. 26.
• left VCR off overnight, and turned it back on after 9:00 AM the next day.
If channel updating
was successful... If VCR could not
distinguish channel map...
Press ACTION
to exit this mode. Press ACTION
to display “SELECT
VCR Plus+ CH”
Continue with step 2.
To Change or Update Auto VCR
Plus+ System Channel Setup
(E.g. you selected wrong channel
map or zip code.)
a Do “Auto VCR Plus+ System
Channel Setup (Part 1)”
steps 1 ~ 4 on p. 26.
b Press to select “UPDATE VCR
Plus+ CH” or “SELECT VCR Plus+ CH,”
then press SET.
c If you selected “UPDATE VCR Plus+ CH,”
perform steps 5 ~ 7 in the “Auto VCR
Plus+ System Channel Setup (Part 1)”
section on p. 26.
If you selected “SELECT VCR Plus+ CH,”
perform steps 2 ~ 3 in the “Auto VCR
Plus+ System Channel Setup (Part 2)”
section on this page.
Press ACTION
to end.
• Make sure to leave VCR off (overnight).
Repeat these steps as necessary.
If Auto Setup fails, do “Manual VCR Plus+
System Channel Setup” on p. 28.
Channel map will be updated (overnight).
If it was successful, “VCR Plus+ CH SET
COMPLETED” appears on screen. And then,
press ACTION to exit.
1
2
3
*Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
END : ACT I ON
VCR Plus+ CH SET
COMPLETED
VCR Plus+ CH SET UP
NEXT : ACT I ON
PLEASE SELECT
VCR Plus+ CHANNEL
VCR Plus+ CH SET UP
SELECT VCR Plus+ CH
KABC CNN ESPN KNBC
12 13 14 15
51 42 18 33
1 5 10 7
101 99 110 78
SELECT :
SET : SET
EXIT : ACT I ON
----------------------------------------
END : ACT I ON
PLEASE LEAVE VCR OFF
(OVERNIGHT)
VCR Plus+ CH SET UP
UPDATE VCR Plus+ CH
SELECT VCR Plus+ CH
SELECT : SET : SET
EXIT : ACT I ON
VCR Plus+ CH SET UP
VCR
Operation