Panasonic PV-D4761 - Manual (Page 34)

34 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Index Search
Note
• If Index Search is started very close to
an index mark, that index mark may not be
counted in the search.
1
2
Tape Operation
Search System
For each recording, an invisible index mark is placed on the tape. A program index and
information are also included for timer recordings. These marks are used to access or
scan recordings.
1
Program End Search
2
Fig. 1
Fig. 2
Fig. 3
Note
Locates end point of recording for continuity.
Examples of Program End Search.
If search exceeds
a few seconds in
BLANK area.
-->search continues 7 sec. past end point,
-->tape rewinds to 10 sec. before end point,
-->tape plays to end point and stops.
Upon locating end point,
• If Program End Search is started very close to
an index mark, that mark may be skipped over.
PROGRAM END SEARCH
SEARCH START : FF
EXIT :SEARCH
Program 2 or BLANK Program 1
the current tape position
Press SEARCH button
FF
INDEX
End Point
Program 2 Program 1
the current tape position
Press SEARCH button
INDEX INDEX
BLANK BLANK
FF
End Point
Program 2 Program 1
the current tape position
Press SEARCH button
BLANK
INDEX
FF
End Point
INDEX SEARCH
ENTER INDEX NUMBER :1
USING 1- 9 KEYS
FORWARD SEARCH :FF
REVERSE SEARCH :REW
NEXT :SEARCH
EXIT :STOP
INDEX SEARCH
FORWARD SEARCH : FF
REVERSE SEARCH : REW
Press SEARCH*
to display SEARCH
in Stop or Play
mode, and then
press NUMBER
keys
to select recording
number.
• To calculate number,
see below.
Press FF/SLOW+
or REW/SLOW-
to start search.
Press SEARCH twice
to display SEARCH in Stop
or Play mode.
Press FF/SLOW+
to start
PROGRAM
END SEARCH.
• To cancel, press
PLAY or STOP.
Play begins at
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
REW/SLOW-
while screen left is
displayed (10 sec.).
• To cancel, press
PLAY or STOP.
To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
NOTE: indicates start points of each recording.
6 1 5 7 2 3 4
1 7 5 3 4 6 2