Panasonic PV-D4761 - Manual (Page 29)

29 [email protected]
To Make Corrections,
press repeatedly
to delete number, then
repeat step 3.
Press PROG/VCR+ button
to display “SET PROGRAM.”
Press PROG/VCR+ button
to end program.
Press
to select record speed,
and
press SET.
3
2
1
4
5
6
Do normal Timer Record if...
• PlusCode number is not listed for
program.
• the program (e.g. sports event)
may run over set stop time.
See p. 25 to:
• cancel Timer Recording in progress.
• review, replace, or clear program
contents.
Important for DSS/ Cable Box Users
• When recording via DSS, the receiver
must be left on. When recording
via cable or antenna, DSS Receiver
must be off.
• When recording via Cable Box, leave
the box on.
Notes
Ready Checklist
Clock is set.
VCR Plus+ Setup is complete (see pp. 26 ~ 28).
• Press ADD/DLT
to delete the program.
• If the PlusCode number entered begins with “0”,
skip to step 5. Display in step 4 will not appear.
*Important: If a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.
ADD/DLT
NUMBER
keys
SET
ACTION
PROG/
VCR+
VCR Plus+ System Programming
Press NUMBER keys
to enter PlusCode number
and
press SET.
Press PROG/VCR+ button
to exit.
• Do not overlap program times.
• PlusCode numbers cannot be used to
program VCR to record DSS and
Cable Box channels.
• Make each entry within 1 minute or
the VCR will exit setup mode.
• Once VCR Plus+ Channel Setup is
done, channels stay in memory.
If a power interruption occurs,
VCR Plus+ Channel Setup may be lost.
Please do VCR Plus+ Channel Setup
again.
(continued)
Press
to select “ONCE,”
“DAILY (MON ~ FRI),” or
“WEEKLY” record
frequency and
press SET.
• Obtain unlisted PlusCode numbers
by calling 1 - 900 - 454 - 7587. Call
costs about $.95 per minute.
Press
to select “VCR Plus+
PROGRAMMING” and
press SET
to display VCR Plus+ screen.
SELECT
T I MER PROGRAMM I NG
VCR Plus + PROGRAMMING
SELECT : SET : SET
EXIT : PROG
SET PROGRAM
SET : SET
ENTER PLUSCODE NUMBER
USING 0 - 9 KEYS
BACKSPACE :
1
VCR Plus+ SYSTEM
SELECT :
SET : SET
ONCE
DAILY(MON-FRI)
WEEKLY
VCR Plus+ SYSTEM
8 SAT SAT 10 10:00 00P P 12 12: 00 00 P 02 02
DATE START STOP CH
SP
SE SE LE CT RECORD SPEED RECORD SPEED
SELECT :
SET : SET BACK :
END : PROG
TODAY - - - - - - - - -- - - - - - - -- - - - - - -
P DT START STOP CH SPD
1 1 8 8 10 10 : 00 00 P 12 12 : 00 00 P 02 SP SP
2 -- -- : -- -- : -- -- --
3 -- -- : -- -- : -- -- --
4 -- -- : -- -- : -- -- --
CANCEL : ADD / DLT
SELECT 1-8 :
ENTER : SET
EXIT : PROG
• Although you can do Timer Recording either
power off or on, you’ll need to turn power off for
Auto Set of “VCR Plus+ CH SET UP” except
watching a disc. (See p. 26).
VCR
Operation