Perle Systems 5500208-43 User Manual
Page 34
35
Configuring Users
level
The access that a user is allowed:
z
Admin—The admin level user has total access to the IOLAN. You can create more
than one admin user account but we recommend that you only have one. They can
monitor and configure the IOLAN.
z
Normal—The Normal level user has limited access to the IOLAN. Limited CLI
commands and Menu access are available with the ability to configure the user’s
own configuration settings.
z
Restricted—The Restricted level user can only access predefined sessions or
access the Easy Port Access menu.
z
Menu—The menu level user will only be able to access predefined session or
access the Easy Port Access menu. The Easy Port Access allows the user to
connect to the accessible line without disconnecting their initial connection to the
IOLAN. Does not have any access to CLI commands.
password
The password the user will need to enter to login to the IOLAN. This case-sensitive
field accepts a maximum of 16 characters.
line-access
Specifies the user access rights to each IOLAN device line. Options are:
z
Read/Write—Users are given read and write access to the line.
z
Read In—Users are given access to read only outbound data, data that is going
from the IOLAN to the device.
The
on|off
option is only for 1-port models. You can disable line access in 2-port +
models by specifying
0
(zero).
service
The type of service that the user will use.
sess-timer
The amount of time, in seconds, that the
Session Timer
will run. Use this timer to
forcibly close a user’s session (connection). When the
Session Timer
expires, the
IOLAN will end the connection. The default value is
0
(zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967
seconds. The
User Session Timer
will override the
Line
Session Timer
, with the exception of reverse Telnet sessions.
port
When the
User Service
is
Telnet
, this is the target port number. The default value will
change based on the type of
Service
selected; the most common known port numbers
are used as the default values.