Set line service – Perle Systems 5500208-43 User Manual

Page 42

Advertising
background image

43

Line Commands

Set Line Service

echo-suppression

This parameter applies only to

EIA-485

Half Duplex

mode. All characters will be

echoed to the user and transmitted across the serial ports. Some EIA-485 applications

require local echo to be enabled in order to monitor the loopback data to determine that
line contention has occurred. If your application cannot handle loopback data, echo

suppression should be

On

. The default is echo suppression

Off

.

speed

Specifies the baud rate of the line; keep in mind that speed is affected by the length of

the cable. You can also specify a custom baud rate; valid values are 50 - 1843200.

Description Sets the service for the line. For services that need further configuration, see

Line

Service Commands on page 46

to find the Line Service that you want to configure.

User Level Admin
Syntax

set line .|<number>|* service bidir <config_host> <server_port>

<host_port>

set line .|<number>|* service direct raw <config_host>

<host_port>

set line .|<number>|* service silent raw <config_host>

<host_port>
[multihost all|backup <config_backup_host> <host_port>|none]

set line .|<number>|* service direct|silent telnet <config_host>

[<host_port>]

set line .|<number>|* service reverse raw [multihost

on|off]|telnet <server_port>

set line .|<number>|* service client-tunnel <config_host>

<host_port>

set line .|<number>|* service server-tunnel <server_port>

set line .|<number>|* service dslogin|udp|vmodem|modbus-master|

modbus-slave|custom-app

set line .|<number>|* service trueport client-initiated off

<config_host> <host_port> [signal-active on|off]
[multihost all|backup <config_backup_host> <host_port>|none]

set line .|<number>|* service trueport client-initiated on

<server_port> [signal-active on|off] [multihost on|off]

Options

bidir
This service allows the IOLAN to listen for incoming TCP connection and if needed,

initiate a TCP connection.

<config_host>

The name of the target host. The host must exist in the IOLAN host table.

<server_port>

The IOLAN port number.

Advertising