Set udp – Perle Systems 5500208-43 User Manual
Page 47
48
Line Service Commands
Set UDP
Description Configures the UDP settings for the serial line.
User Level Normal, Admin
Syntax
Options
entry 1|2|3|4
Selects which of the 4 available entries we wish to define/modify. For each entry the
user can specify a different IP address range, UDP port and direction of data flow.
both|in|out|none
auto-learn
The IOLAN will only listen to the first port that it receives a UDP packet from.
Applicable when set to
In
or
Both
.
any-port
The IOLAN will receive messages from any port sending UDP packets. Applicable
when set to
In
.
specific
The port that the IOLAN will use to relay messages to servers/hosts or the port from
which the IOLANN will receive messages to be forwarded to the serial port. This
option works with any setting except
None
. The IOLAN will listen for UDP packets on
the port configured by the
DS Port
parameter.
<outbound_port>
<start_ip_address>
<end_ip_address>
set udp line .|<number>|* entry 1|2|3|4
both auto-learn|specific <UDP_port> [<start_IP_address>]
[<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 in
any-port|auto-learn|specific <UDP_port> [<start_IP_address>]
[<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 out <UDP_port>
[<start_IP_address>] [<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 none
The direction in which information is received or relayed:
z
None—UDP service not enabled.
z
In—LAN to serial.
z
Out—Serial to LAN.
z
Both—Messages are relayed both directions.
The port that the IOLAN will use to relay messages to servers/hosts. The IOLAN will
listen for UDP packets on the port configured by the
DS Port
parameter.
The first host IP address in the range of IP addresses (for IPV4 or IPV6) that the
IOLAN will listen for messages from and/or send messages to.
The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
that the IOLAN will listen for messages from and/or send messages to.