Paradyne 6800 - Manual (Page 212)

Loading and Restoring Software
5-51 6800-A2-GN22-30 January 1997
The system prompts:
Does daylight saving time (summer time) apply at your location? (y/n)
TYPE: y or n (as appropriate to your location)
PRESS: Enter
4. Execute the installpkg command and begin the installation process:
TYPE: installpkg
PRESS: Enter
The installation program prompts you to insert a floppy disk into the disk drive and press
Enter.
5. Insert the disk labeled 6800 UIP Application Volume 6 into the floppy drive and the 6800
UIP Application Volume 7 into the tape drive, then
PRESS: Enter
A series of status messages confirms that the installation program is reading and processing
the contents of the floppy disk.
NOTE
If the UIP is active, an error message appears indicating that the
software cannot be installed.
6. At this point, the installation program checks for the existence of a previous release of the
UIP (if this is the first time UIP is being installed on this System 5000, you may skip this
step and go directly to Step 5.). If the system finds a previous release and the UIP system is
active, the system terminates the installation and issues a message telling you to stop the
UIP and then re-execute installpkg.
7. If the installation program finds a previous release of the UIP that is inactive, the system
continues with the installation and check for active workstations. If one is found, the
system displays a message indicating this and asks you if you want to continue. To
continue, you have to terminate the active workstation.
There are active workstations. Do you wish to continue? (y/n) [y]:
TYPE: y
PRESS: Enter
To terminate the installation instead of the active workstation, enter n instead.
Finally, the installation program prompts you to remove the previous release. To remove it
and proceed with the installation.
The UIP has been previously installed. The existing UIP will be removed if you
continue. Do you wish to continue (y/n)?
TYPE: y
PRESS: Enter