Paradyne 6800 User Manual
Page 64
Preparing the Processors
2-41
6800-A2-GN22-30
January 1997
4. On the jumper labeled J1, check that the jumper is on Pins 2 and 3 to set the local program
memory to 16 Kb.
5. Follow the instructions under Installing Circuit Cards in the System 15000 to install the
IPC-1600 card in Slot 2 of the System 15000.
Preinstallation Steps for the DCP-MUXi Cards on the System 15000
To prepare the DCP-MUXi cards for installation on the System 15000, refer to Figure 2-7 and
perform the following steps:
1. Remove two jumpers from each card, the first at position E32-E33 (interrupt request) and
the second at position E37-E38 (transparent mode interrupt). You may store a jumper for
future use, such as running diagnostics, by placing it on one pin only.
2. Verify that all other jumpers on the cards are as shown in Figure 2-7.
3. On the block SW1, set the I/O addresses as shown in Table 2-7.
Table 2-7
DCP-MUXI — I/O Address Switch Settings
Description
1
2
3
4
DCP-MUXI #1 (Slot 4)
on
on
off
off
DCP-MUXI #2 (Slot 5)
on
on
on
off
4. Follow the instructions under Installing Circuit Cards in the System 15000 to install the
DCP-MUXi cards in Slots 4 and 5 of the System 15000.