Pioneer CNDV-40R - Manual (Page 106)

104
Appendix
Setting of the Installation direction
lever is wrong. Check the installation position of the
navigation unit of your Navigation
System and the setting of the Instal-
lation direction lever (
➞
“Installation
Manual”).
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing. Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The Navigation Sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
The map continually reorients itself. The traveling direction is always set
to north. Check the “Map Orientation” set-
tings (
➞ Page 51
) and change the
setting to “North Up”.
Tracking marks are not displayed. The “Tracking Display” is turned
off. Check the “Tracking Display” set-
tings (
➞ Page 50
) and make sure
“Always” or “This Trip” is selected.
The daylight display is used even
when the vehicle lights are on. Daytime is selected on “Day/Night
Display”. Check the “Day/Night Display” set-
ting (
➞ Page 50
) and make sure
“Nighttime” is selected.
The Orange/white lead is not con-
nected. Check the connection.
The system will not switch on or will
not operate. Installation or connection has been
carried out incorrectly. Check with your dealer.
The display is very dim. The vehicle’s light is turned ON, and
“Nighttime” is selected on “Day/
Night Display”. Read about the “Day/Night Dis-
play” setting (
➞ Page 50
) and, if
desired, select “Daytime”.
The vehicle cabin temperature is
extremely low. A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
There is no voice guidance or the vol-
ume is low. The volume setting is low or the
speaker lead is disconnected. Check the volume setting on the dis-
play or turn the volume up according
to “Hardware Volume” (
➞
Page 50 ) and/or turn up the volume
on the display.
The remote control fails to work. The batteries are low. Change the batteries.
The batteries have been inserted
incorrectly. Check that the batteries are properly
inserted according to the + and –
markings.
The remote control is pointing at the
floor or a seat. Ensure that the remote control has a
clear line of sight to the display unit.
The signal receptor on the display is
exposed to direct sunlight. Move the remote control closer to the
receiver on the display unit.
Settings of the dipswitch are wrong. Specify it correctly according to the
equipment. (
➞ Page 94
)
Setting of the operation mode switch
is wrong. Switch the operation mode switch to
“NAVI” to operate navigation.
When operating AV equipment,
switch the operation mode switch
correctly according to the equipment
to use. (
➞ Page 54
)
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to “Acc off”. Then
start the engine again, and turn the power to the navigation unit back on. If this does not solve the
problem, press the RESET button on the navigation unit.
Symptom Cause Action (See)