Panasonic DMC-G5 User Manual
Page 102
- 102 -
Recording
∫
Displaying the MF Assist
•
This is displayed by moving the focus lever, rotating the focus ring, or touching the screen. (In the
Creative Control Mode [Miniature Effect], MF Assistance cannot be displayed by touching the
screen)
•
It can also be displayed by pressing
2 to display the setup screen for the enlarged area, deciding
the area to enlarge using the cursor button, and then pressing [MENU/SET].
•
It will switch to the setting screen for the enlarged area by pressing the cursor button when the
[Direct Focus Area] in the [Custom] menu is set to [ON].
∫
Changing the display of the MF Assist
You can switch the magnification factor between approx. 4 times, 5 times and 10 times. In the
case of 4 times magnification, the central region is magnified. In the case of 5 and 10 times
magnification, the whole screen is magnified.
•
You can change the magnification by touching [
]/[
] or rotating the rear dial.
∫
Moving the enlarged area
•
The enlarged area can be moved by dragging the screen
, or pressing the cursor button.
•
The following will return the MF assistance to the original position.
–
When the [Focus Mode] is set to other than [MF]
–
Changing [Aspect Ratio] or [Picture Size]
–
Turning the camera off
–
When [Reset] is touched in the setup screen for the enlarged area
∫
Closing the MF Assist
•
It will close when the shutter button is pressed halfway.
•
It will also close by touching the [Exit] on the screen or pressing [MENU/SET].
•
When displayed by moving the focus lever or rotating the focus ring, it is closed approximately
10 seconds after operations are stopped.
Note
•
The MF Assist is disabled when using the Digital Zoom or recording motion pictures.
•
MF Assist or MF guide may not display depending on the lens used, but you can display MF Assist
by direct operation of the camera, using the touch screen or a button.
MF ASSIST