Pioneer RCS-606H - Manual (Page 144)

Additional information 16
144
En
• Please perform HDD optimization. This
can be done using Disc Setup. The HDD is in more urgent need of optimization in order to maintain
performance.
• The HDD has not been sufficiently opti-
mized. Please optimize again. If this message appears repeatedly after optimizing the HDD it is likely
that there is not enough free space on the HDD for optimization to
complete properly. Please erase some titles from the HDD and optimize
again.
• This channel’s TV system is different
from the recorder’s setting. The TV system (PAL, NTSC, etc.) of the current channel is different from
the TV system settings of this recorder.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear
message. The timer recording failed because the TV system of the channel set for
recording was different from the setting of the recorder.
• Playback has stopped because the TV
system is different than the recording. During recording or timer recording standby, the TV System (PAL, NTSC,
etc.) of the playback video changed, causing playback to stop
automatically.
No DV camcorder connected. The camcorder is not connected properly, or the camcorder is switched
off.
You cannot connect more than one DV
camcorder at a time. This recorder’s DV jack supports connection to just one camcorder.
Cannot operate the DV camcorder. This recorder cannot operate the DV camcorder. Try switching off the
camcorder then turn it back on again.
Could not operate the DV camcorder. This recorder was not able to operate the DV camcorder.
The DV camcorder is not set for playback.
Please select playback mode on the DV
camcorder. The camcorder is in camera mode. Switch it to playback mode.
Searching for printer. Please wait a
moment. This message is displayed when the recorder is scanning for a
connected printer, or when the printer is not yet ready for printing. If
there is no printer connected, please connect one.
The printer is not ready or there is no
printer connected. Please check the
printer status. This message is displayed when communication could not be
established with the printer. See the Troubleshooting section if you do not
know the cause.
Printing has stopped because ... This message is displayed when there is a printer error during printing.
After checking the printer for the cause of the error, select “Yes” to
resume printing. Select “No” to cancel the print job. See also the
operating instructions that came with your printer for possible causes of
print errors.
The print job has been canceled because
... This message is displayed when there is a printer error during printing.
After checking the printer for the cause of the error, reconnect the printer
and start the printing job again. See also the operating instructions that
came with your printer for possible causes of print errors.
Message Explanation/Action