Pioneer RCS-606H - Manual (Page 36)

Other connections 06
36
En
Automatic plasma display volume muting
When Volume Control is switched on, the volume of the
plasma display is automatically muted when the receiver
subwoofer is switched on, or the receiver subwoofer
function is changed to one that you would want to hear
the sound from the receiver subwoofer rather than the
plasma display (DVD, for example).
• VOL.C ON – When this unit is switched on, or the
input function is changed, the volume on the plasma
display is muted so only sound from this unit is
heard.
• VOL.C OFF – This unit does not control the volume of
the plasma display
Automatic plasma display input switching
In order that the plasma display can switch automatically
to the correct input when you switch the input function of
the receiver subwoofer, you need to tell it how your
system is connected.
For example, if you connected your DVD recorder to the
DV1 input on the receiver subwoofer, and to input 2 on
your plasma display, select the
DV1 PDP2 setting here so
that when you switch the input function of the receiver
subwoofer to
DV1 to watch your DVD recorder, the
plasma display will automatically switch to input 2.
For each receiver subwoofer input function ( DV1 (DVD/
DVR1), DV2 (DVD/DVR2), DIG (DIGITAL), ANA
(ANALOG)) you can select:
• NONE – does not switch the plasma display input
• PDP1 to PDP5 – switches the plasma display input to
one of the numbered inputs (1 to 5)
• TVTN – switches the plasma display to its built-in
TV tuner
Note
• The number of video inputs available will depend on
the plasma display you’ve connected.
• The PDP5 input may be called ‘PC Input’ (or similar)
on your plasma display.
• The SR+ setting remains in effect even in standby.
• The SR+ setting does not affect the FM/AM tuner
function.
Using the SR+ mode with a Pioneer plasma
display
1 Press SR+ on the remote.
2 Use
/ to select SR+ ON then press ENTER.
• The SR+ setting is maintained even after switching
the receiver subwoofer into standby then back on.
Automatic muting and automatic input switching
will be effective when the receiver subwoofer is
switched on.
• If you disconnect the SR+ cable or switch the plasma
display off while SR+ is on, the SR+ ON setting
remains.
• To switch to SR+ OFF, follow steps 1 and 2, selecting
SR+ OFF.
Note
• You can control this unit with the plasma display’s
remote sensor even in standby, but you can’t control
this unit with either this unit’s remote sensor or the
plasma display’s remote sensor when the plasma
display is switched off (AC off) and the SR+ cable is
connected to the
CONTROL IN jack of this unit.