Pioneer RCS-606H - Manual (Page 32)

Surround sound settings 05
32
En
Dynamic Range Control
1
When watching Dolby Digital or DTS material at low
volume, low level sounds—including some of the
dialog—can be difficult to hear properly. Using one of the
Dynamic Range Control (DRC) settings can help by
bringing up the low level sounds, while controlling high
level peaks.
Dynamic Range Control works only with Dolby Digital
soundtracks and some DTS soundtracks.
1 Press SETUP.
2 Use the
/ buttons to select DRC, then press
ENTER.
3 Use / to select a setting.
Select one of the following:
• DRC OFF (default) – No dynamic range adjustment
(use when listening at higher volume)
• DRC MID – Mid setting
• DRC HIGH – Dynamic range is reduced (loud sounds
are reduced in volume while quieter sounds are
increased)
4 Press ENTER to exit.
Dual mono setting
2
Specifies how dual mono encoded Dolby Digital or DTS
soundtracks should be played. You can also use this
setting to switch the audio channel on DVD-RW discs
recorded with bilingual audio.
1 Press SETUP.
2 Use the / buttons to select DUALMONO,
then press ENTER.
3 Use / to select a setting.
Select one of the following:
• CH1 MONO (default) – Only channel 1 is played
• CH2 MONO – Only channel 2 is played
• CH1/CH2 – Both channels are played through the
front speakers
4 Press ENTER to exit.
Adjusting the channel levels using
the test tone
If you prefer, you can set the channel levels using a test
tone as a reference, rather than playing a source (see
Channel level setting on page 31). A test tone is played
through each speaker in turn, allowing you to adjust the
level as it plays.
Note that the channel level settings for stereo sources
are independent of the settings for surround sound
sources.
1 Press SURROUND to select the Auto listening
mode.
• If you want to set the channel levels for stereo (two
channel) playback, select the STEREO listening
mode.
2 Press TEST TONE.
The test tone is output from each speaker in turn.
3 While a test tone is playing, use the / buttons
to adjust that channel level.
The aim is to adjust the levels so that you hear the test
tone at the same volume from each speaker. You can
adjust the level of each channel by ± 10 dB.
• You can adjust the overall volume of test tone output
using the VOLUME +/– buttons (this does not affect
the channel level settings).
• If the system is in Stereo or Virtual mode, you will not
be able to adjust the center or surround channels.
• Because of the ultra low frequencies the subwoofer
produces, it may sound quieter than it really is. We
suggest adjusting the subwoofer level while listening
to a source. See the method described in
Channel
level setting on page 31.
Note
1 This setting is effective for the speaker output. A similar adjustment feature is available on the DVD recorder—see Audio DRC on page 131.
2 This setting is effective for the speaker output. A similar adjustment feature is available on the DVD recorder—see Switching audio channels
on page 94.
MCACC
SURROUND ADVANCED SOUND TV/DVD
SLEEP
INPUT
MAIN SUB
CHANNEL
TV CONTROL RDS DISP
AXD7442
VOLUME DISPLAY
CLEAR JUKE BOX
TEST TONE VIDEO IN
SR + ONE TOUCH COPY
MENU
/TUNE +
ENTER
/ / TIMER REC REC MODE
/TUNE –
1 2 3
4 5 6
7 8
0
+ +
– –
9