Pioneer RCS-606H - Manual (Page 63)

Getting started 04
63
En
English
You should see a grid filled with channel logos and TV
listings information. Use the
/ buttons to review the
list. If you notice that there are channels missing, or that
there are channels in the list that you don’t get, go to the
Editor screen:
• Press repeatedly until the Menu bar is highlighted.
• Press until Editor is highlighted. The main area of
the screen now shows a list of channels. Those that
are turned
ON are displayed in the grid; those that
are OFF are hidden. Use the / / / buttons to
move down the list and turn channels ON or OFF as
necessary.
• For any channel that you turn ON, the GUIDE Plus+
system will need to know how it is received (the
source) and on which program number. The source
may be the built-in tuner of this recorder, or an
external receiver. The program number is the number
on which the channel can be found on its receiving
device/source. The entry in the Editor screen must
match this number for correct recording of that
channel.
• The above is especially important for the ‘host
channel’. Please make sure that the host channel is
always switched
ON.
2 Change the program numbers as you
like.
Changing the program numbers allows you to decide the
order in which the channels change when stepping
through them sequentially. You can do this to group
certain channels together, for example.
3 When you’re done, press the BLUE Action button
(Home) to get back to the GUIDE Plus+ home screen.
• You can find detailed information on using the GUIDE
Plus+ system in the following chapter.
SET UP
MCACC
ADVANCED
TEST TONE
SR + /TUNE +
ENTER
/TUNE –
/ST – /ST +
1 2 3
4 5 6
7 8
0
9